In the previous part of this guide (here), we took a look at how to configure the SysTick to generate ticks for the system for timing, delay etc. Also, in part 1 (here), we saw how to configure the GPIO in analog mode, input and output. In this...
READ MOREIn the previous guide (here), we took a look how to build core configuration for STM32F411. In this guide, we shall see how to use System Time (SysTick) to implement system tick in your board support package. In this guide, we shall cover the...
READ MOREIn the previous guide (here), we took a look at board support package and how to configure a pin to act as input and output. In this guide, we shall build board support package to set the frequency of the core. In this guide, we shall cover the...
READ MOREIn this guide, we shall see what is Board Support package and how to build one for STM32F411-Nucleo64. In this guide, we shall see how to configure the GPIO input mode and output. In this guide, we shall cover the following: What is BSP. Building...
READ MOREIn the previous guide (here), we saw how to configure the ADC with DMA and timer to trigger it periodically. In this guide, we shall see how to use the double buffer mode to increase the potential processing power of STM32F4. In this guide, we...
READ MOREIn the previous guide (here), we took a look how to transmit data over SPI bus using DMA. In this guide, we shall use DMA with SPI in full duplex to transmit and receive at the same time. This will free the CPU to do something else (not covered...
READ MOREIn the previous guid (here), we took a look at HM-10 module and how to connect it to STM32F4. In this guide, we shall use this module in full duplex to control LED and send strings from STM32F4 to a phone. In this guide, we shall cover the...
READ MOREIn this two part series guide, we shall interface HM10 BLE module with STM32 and control an LED and send string from STM32. In this guide, we shall cover the following: What is HM-10. Connection. UART setup. LED Setup. Time base setup. code. 1...
READ MOREIn the previous guide (here), we took a look at HC-12 RF module and setup the environment in STM32CubeIDE. In this guide, we shall continue the environment setup by initializing the user push button as external interrupt and library for HC-12. In...
READ MOREIn this guide, we shall take a look at HC-12 RF long range RF communication module. In this guide, we shall cover the following: What is HC-12. Hardware setup. Serial Setup. LED setup. Time base. Code. 1. What is HC-12: The HC-12 is a half-duplex...
READ MOREIn this guide, we shall see how to interface MPU6050 with STM32F4xx. In this guide, we shall cover the following: What is MPU6050. Connection. Developing the driver. Code. Results. 1. What is MPU6050: The MPU-6050™ parts are the world’s...
READ MOREIn the previous guide (here), we took a look how to configure the timer to generate PWM signal and update the duty cycle in software. In this guide, we shall configure the time with PWM to update the duty cycle using DMA. In this guide, we shall...
READ MOREAll Rights Reserved