In the previous guide (here), we saw to configure the ADXL345 to work in I2C mode and get the acceleration values. In this guide, we shall use the same sensor is SPI mode. In this guide, we shall cover the following: Connection. Pin...
READ MOREIn this guide, we shall take a look at the thermocouple and how this type of sensor works and use MAX6675 thermocouple to measure the temperature. In this guide, we shall cover the following: Thermocouple typeK MAX6675. Connection MAX6675 with...
READ MOREIn the previous guides, we took a look at FIR and IIR filters and in this guide, we shall take a small introduction to Kalman filter and how to use it filter ADC signal from out STM32F7 board. In this guide, we shall cover the following: Kalman...
READ MOREIn previous two guides (part one and part 2) we looked at the ADC conversion using two methods, first one was single conversion and seconds was continuous conversion. The two methods proven to be effect in certain area. however, we have to wait...
READ MOREAll Rights Reserved