Working with STM32 and Acceleration Sensor: ADXL345 in SPI mode Part 2
In part 1 (here), we saw to configure the SPI and other parameters required for ADXL345 operation in SPI mode. We shall continue from…
STM32F4
Examples explicitly targeting the STM32F4 family.
296 articles · Page 23 of 30
Articles
Working with STM32 and Acceleration Sensor: ADXL345 in SPI mode Part 1
In the previous guide (here), we saw to configure the ADXL345 to work in I2C mode and get the acceleration values. In this guide,…
Working with STM32 and Acceleration Sensor: ADXL345 in I2C mode
In this guide, we shall see how to interface STM32F4 with acceleration sensor ADXL345 using I2C mode. In this guide, we shall cover the…
Settings Up STM32CubeIDE for Bare Metal Programming
In this guide, the installation of the IDE is presented. In this guide, we shall cover the following: Installing the IDE Constructing the correct…
Working with STM32F4 and SPI-TFT: ST7789 IPS 240×240 LCD
This guide shows how to interface the STM32F4 board with ST7789 TFT display.The ST7789 TFT module contains a display controller with the same name:…
NEC Protocol Decoding with STM32 Part 3: Decoding algorithm
In the previous guide (here), we saw how to configure the required peripherals. In this guide we shall see how to develop the algorithm…
NEC Protocol Decoding with STM32 Part 2: Peripherals Setup
In the previous guide, we took a look at the NEC IR protocol and setup STM32 to run at 64MHz. In this guide, we…
NEC Protocol Decoding with STM32 Part 1: Introduction
In this guide series, we shall see how NEC protocol works and how to decode the commands from NEC enabled IR Remote. In this…
STM32 and Nextion Display Part 5: Graph display
In the previous guide (here), we took a look how to control the LED brightness using sliders. In this guide, we shall see how…
STM32 and Nextion Display Part 4: LED Brightness Control
In the previous guide (here), we took a look how to control two LED using touch toggle switches. In this guide, we shall see…