Working with STM32 and sensors: DHT11
In this article, we shall look at the dth11 temperature and humidity sensor and how does it work and interface it with STM32F4 Nucleo-64…
Author: Husamuldeen
505 articles · Page 47 of 51
Articles
Working with STM32F7 and UART part 1: Sending a single character
In this guide, we shall discuss how to use the UART module on STM32F7xx specifically, STM32F767ZI Nucleo. In this guide we will cover the…
Working with STM32 and sensors: MPU9250
Ever heard of MPU-9250? It is a multi-chip module (MCM) which consists of 2 dies, and houses the 3-Axis gyroscope and the 3-Axis accelerometer!…
Working with STM32F7 and Timers: Delay using timer
In this guide, we shall investigate how to use timer to generate precise delay in down to microseconds ( will use 1 second delay…
Working with STM32 and I2C: Using DMA Mode
In the previous guides, we took a look how to scan the i2c bus for peripherals (here), read single byte (here), write single byte…
Working with STM32 and Displays: SSD1306 I2C OLED display
This tutorial teaches you how to interface an OLED display with STM32F411. In this article, we will show how to use SSD1306 0.96 inch…
Working with STM32F7 and ADC part 3: Single channel Continuous Conversion with interrupt
In the previous guide (here), We took a look for how the continuous conversion working in polling mode, in this guide, we shall use…
Working with STM32 and Liquid Crystal display: 4-bit mode
In this guide, we shall see how to use alphanumeric display. In this guide, we shall cover the following: Liquid Crystal display Initializing sequence…
Working with STM32 and Motors part 3 : NEMA 17 Stepper Motors
In the previous guide (here), we took a look how to control 28BYJ-48 stepper Motor. In this guide, we shall see how control NEMA17…
Working with STM32 and Timers part 6: Output Compare
In the pervious guide (here), we took a look how to configure the timer in encoder mode to read the pulses generated by the…