Working with STM32 and I2C: Writing Multiple Bytes
In the pervious guide, we took a look how to read multiple bytes using I2C (here). In this guide, we shall cover how to…
Author: Husamuldeen
504 articles · Page 48 of 51
Articles
Working with STM32F7 and ADC part 1: Single channel Single Conversion
In the previous guide, we took a look at the STM32F7 blinking LED (here) and how to change the core frequency to push it…
Working with DMA and STM32: Memory to Memory Mode
In pervious multiple guides, we took look at ADC with DMA (here), USART with DMA (here) and SPI-TX with DMA (here). In this guide,…
Working with STM32 and I2C: Reading Multiple Bytes
In the pervious guid (here), we took a look how to write/read single byte using I2C and the slave device is DS3231 In this…
Working with STM32 and Motors part 2 : DC Motors
In the pervious guide (here), we took a look at how to control stepper motor. This guide is about DC motor interfacing with STM32F411…
Changing core frequency of STM32F767 using registers only
In this guide, we shall use registers to change the core frequency from default 16MHz to 216MHz (maximum for F767ZIT). We shall use CubeMX…
Working with STM32 and I2C: Writing a single Byte
In the pervious guide (from here), we took a look at DS3231 hardware and we read the second register and display the seconds on…
Getting started with STM32F7: Blinking LED
In this new guide series, we shall start developing peripheral for ARM Cortex M7 based MCU with STM32F7 specially STM32F767Zi Nucelo-144. In this guide,…
Working with STM32 and I2C: Reading single Byte
In the previous guide (here), we saw how to use I2C to scan the bus for the slave devices address. In this guide, we…
Working with STM32 and Motors part 1 : Stepper Motor
In this guide,, we will learn to interface a stepper motor with STM32F411RE Nucleo-64. There are many options available for stepper motors. But in…