Working with STM32F7 and ADC part 1: Single channel Single Conversion
In the previous guide, we took a look at the STM32F7 blinking LED (here) and how to change the core frequency to push it…
Peripheral Drivers
483 articles · Page 45 of 49
Articles
Working with DMA and STM32: Memory to Memory Mode
In pervious multiple guides, we took look at ADC with DMA (here), USART with DMA (here) and SPI-TX with DMA (here). In this guide,…
Working with STM32 and I2C: Reading Multiple Bytes
In the pervious guid (here), we took a look how to write/read single byte using I2C and the slave device is DS3231 In this…
Working with STM32 and Motors part 2 : DC Motors
In the pervious guide (here), we took a look at how to control stepper motor. This guide is about DC motor interfacing with STM32F411…
Working with STM32 and I2C: Writing a single Byte
In the pervious guide (from here), we took a look at DS3231 hardware and we read the second register and display the seconds on…
Getting started with STM32F7: Blinking LED
In this new guide series, we shall start developing peripheral for ARM Cortex M7 based MCU with STM32F7 specially STM32F767Zi Nucelo-144. In this guide,…
Working with STM32 and I2C: Reading single Byte
In the previous guide (here), we saw how to use I2C to scan the bus for the slave devices address. In this guide, we…
Working with STM32 and Motors part 1 : Stepper Motor
In this guide,, we will learn to interface a stepper motor with STM32F411RE Nucleo-64. There are many options available for stepper motors. But in…
Working with SPI displays and STM32: Driving ST7735
In the pervious guide, we took a look at how to send data over SPI (from here). In this guide, we shall use SPI…
Working with STM32 and ultrasonic: using timer and interrupt to measure the distance
In the previous guide(here), we looked at the operation principle of how ultrasonic works and we used very crude code to measure the distance.…