Getting started with STM32L053: ADC Multi Channel Continuous Conversion with DMA
In the previous guide (here), we took a look at the continuous mode for ADC module of STM32L0. In this guide, we shall see…
Peripheral Drivers
483 articles · Page 38 of 49
Articles
NEC Protocol Decoding with STM32 Part 3: Decoding algorithm
In the previous guide (here), we saw how to configure the required peripherals. In this guide we shall see how to develop the algorithm…
NEC Protocol Decoding with STM32 Part 2: Peripherals Setup
In the previous guide, we took a look at the NEC IR protocol and setup STM32 to run at 64MHz. In this guide, we…
NEC Protocol Decoding with STM32 Part 1: Introduction
In this guide series, we shall see how NEC protocol works and how to decode the commands from NEC enabled IR Remote. In this…
STM32 and Nextion Display Part 5: Graph display
In the previous guide (here), we took a look how to control the LED brightness using sliders. In this guide, we shall see how…
STM32 and Nextion Display Part 4: LED Brightness Control
In the previous guide (here), we took a look how to control two LED using touch toggle switches. In this guide, we shall see…
STM32 and Nextion Display Part 3: LED Control
In the previous guide (here), we saw how to how to send strings from STM32 to Nextion display. In this guide, we shall see…
STM32 and Nextion Display Part 2: Sending Strings
In the previous guide (here), we saw how to setup Nextion editor and STM32F4 to work with Nextion display. In this guide, we shall…
STM32 and Nextion Display Part 1: Environment Setup
In this guide, we shall see how to work with Nextion display with STM32. In this part of guide, we shall cover the following:…
Getting started with STM32L053: I2C Write Mode
In this guide, we shall see how to configure I2C in STM32L053 to write to a specific register of an I2C device (DS3231 in…